How to read a dial caliper
Step by step with pictures: the parts, how to zero and measure, then how to read the bar and the dial. Each step shows the caliper with the part you are reading marked.
How to read a dial caliper, step by step
1 Know the parts
The beam carries the main scale. The sliding jaw moves along it: roll it with the thumb roller and hold it with the lock screw. The big outside jaws measure across a part, the small inside jaws measure holes and slots, and the depth rod comes out of the end to measure how deep something is. The dial reads the thousandths: one turn of the needle is 0.100".
2 Measure the outside of a part
- Wipe the jaws, close them and check the caliper reads zero. On a dial caliper, turn the bezel until 0 sits under the needle.
- Open the jaws wider than the part, then close them gently and squarely on it. Use the part of the jaws near the beam, not the tips.
- Light, even pressure. Squeezing hard bends the jaws and reads small.
- Read it on the part, or lock it and lift it off.
3 Read the bar
The bar is marked in inches and tenths of an inch (0.100"). Read the last mark the edge of the slide has passed.
4 Read the dial
The dial has 100 marks, each 0.001". One full turn of the needle is 0.100", the space between two tenth marks on the bar.
5 Add them up
Bar plus dial: 1.237".
6 When the slide is right next to a mark
Near a tenth mark it can be hard to tell from the bar if the mark has been passed. Trust the dial. A needle in the high 90s means the mark is not passed yet. A needle at 0 to 5 means it just was.
Try it yourself
Slide the jaw along the bar and watch the needle turn. One full turn of the dial is one tenth of an inch on the bar.
Keeping it on zero
Check zero whenever you drop the caliper or get odd readings: wipe the jaws, close them and turn the bezel until 0 sits under the needle, then tighten the bezel lock. Dirt in the rack is the usual reason a dial jumps.
Metric dial calipers
Metric dial calipers are read the same way. Read the whole millimetres on the bar, then add the dial. On a 0.01 mm caliper one turn of the needle is 1 mm, so 16 mm on the bar plus 13 on the dial is 16.13 mm. Some metric dials read 0.02 mm per division with 2 mm per turn, so always check the value printed on the face. Use the Metric button above to try one.
Practise reading a dial caliper
Questions
How do you read a dial caliper?
Read the inches and tenths from the bar, read the thousandths from the dial, and add them. 1.2" on the bar plus 37 on the dial is 1.237".
How much is one turn of a dial caliper?
On an inch dial caliper, one full turn of the needle is 0.100", one tenth of an inch. On a 0.01 mm metric dial caliper, one turn is 1 mm.
How do you read a metric dial caliper?
Read the whole millimetres on the bar, then add the dial. 16 mm on the bar plus 13 on a 0.01 mm dial is 16.13 mm.
Why does my dial caliper not read zero when closed?
The bezel has moved or there is dirt between the jaws. Clean the jaws, close them, and turn the bezel so 0 is under the needle.
Sources
Measure Drill checks every number against these references or works it out from the exact definitions of the units.