Tape measure test practice
Many employers check that you can read a tape measure before they hire you. Take the free quick test now, then the full timed test when you are ready.
What is on a tape measure test?
Every employer writes their own, but they usually check the same things: reading a tape measure or ruler to the nearest 1/16", writing the fraction in lowest terms, and sometimes reading in feet and inches. Some tests also ask you to add or subtract two measurements, which you can practise with the feet and inches calculator. We do not have, and do not copy, any employer's test. This is practice of the same skill under the same kind of time pressure.
How our test works
- Every question is a fresh drawing, so you can take it again and again.
- Type each reading the way you would write it on paper, like 5 3/8 or 2' 3 5/16". Unreduced fractions like 6/16 are marked right, but get used to reducing them.
- A timer runs the whole time and the test is marked automatically when it reaches zero.
- At the end you see every question again with the right reading and how to get it.
Tips to pass
- Learn the mark lengths so you can see halves, quarters and eighths without counting.
- Always start counting from the last whole inch, never from the next one.
- Reduce every fraction: if the top number is even, halve both numbers.
- Do not spend more than 30 seconds on one question; skip it and come back.
- Practise on the tape measure page until level 4 feels easy.
Questions
What is on a tape measure test for a job?
Usually reading tape measures or rulers to the nearest sixteenth of an inch, sometimes in feet and inches, and sometimes adding or subtracting measurements.
How do I pass a tape measure test?
Learn which mark is a half, quarter, eighth and sixteenth by its length, count from the last whole inch, reduce the fraction, and practise under a timer until it is quick.
Is this the real test my employer uses?
No. It is practice of the same skill. We do not have or copy any employer's test.
Is the test free?
Yes. The quick test and the full 25 question timed test are both free and unlimited.
Sources
Measure Drill checks every number against these references or works it out from the exact definitions of the units.