Free picture lesson and practice
How to read a protractor
Most protractor mistakes come from reading the wrong row of numbers. Learn which scale to use, swing the arm on screen, then practice until it is automatic.
The parts of a protractor
- Center mark
The small hole or cross at the middle of the straight edge. It goes on the corner of the angle. - Base line
The straight line through the center mark, from 0 on one side to 180 on the other. - Outer scale
Counts from 0 on the right up to 180 on the left. - Inner scale
Counts from 0 on the left up to 180 on the right.
How to read a protractor, step by step
- Put the center mark on the corner of the angle, where the two arms meet.
- Line the base line up with one arm.
- Pick the scale that reads 0 on that arm. If the arm points right, use the outer scale. If it points left, use the inner scale.
- Follow the other arm to that scale, find the numbered mark just before it and count the small marks. Each small mark is 1°.
- Check the size. A narrow angle is less than 90° and a wide one is more than 90°. If your number does not match, you read the other row.
Try it yourself
Drag the slider to swing the red arm. Watch both rows: the outer row gives the angle because the base arm points to 0 on the right.
Practice reading it
Pick a level and read the angle between the two arms. On the harder levels the base arm can point left, so choose your row carefully.
Angle names
| Name | Size |
|---|---|
| Acute | More than 0° and less than 90° |
| Right | Exactly 90° |
| Obtuse | More than 90° and less than 180° |
| Straight | Exactly 180° |
| Reflex | More than 180° and less than 360° |
Questions
Which scale do I use on a protractor?
Use the scale that reads 0 on the arm lined up with the base line. Arm pointing right: outer scale. Arm pointing left: inner scale.
Why does a protractor have two rows of numbers?
So you can measure from either side without turning the protractor over. The two rows always add up to 180.
How do I measure an angle bigger than 180°?
Measure the smaller angle on the other side, then take it away from 360. If the small side is 70°, the big angle is 290°.
What if the arms are too short to reach the numbers?
Extend them with a ruler and a light pencil line before you measure.
Keep going
Sources
Measure Drill checks every number against these references or works it out from the exact definitions of the units.